Home of the The Hall of Ma'at on the Internet
Home
Discussion Forums
Papers
Authors

March 28, 2020, 2:01 pm UTC    
RLH
September 12, 2008 03:13PM
HI Don

>>>Hi Rob ...Is this some of the good stuff ?<<<

Well my name is not Rob! And no that is not the good stuff at all!

>>>However I have to call into question the angles you have the shafts drawn in at. I don't believe they are accurate.<<<

That’s a good one! You mark on my cad drawings with a line about 2 cubits thick and at the wrong angles but you are not sure about MY shaft angles!!! At least I got my laugh for the day thanks. smiling smiley They are not my shaft angles they come from Gantenbrink’s data so you need to contact him if you disagree! Also extending the KC south shaft will NOT meet the corner of base and apex extensions.

If you are referring to the KC north shaft (the angle B = 32.4712° I have) it is not the actual shaft angle I use the starting point at the end of the horizontal section and the exit point where it would contact casing. The bending that goes on between start and exit points is not that important.

RLH
Subject Author Posted

7x11 diagonal

RLH September 12, 2008 05:46AM

Re: 7x11 diagonal

Don Barone September 12, 2008 08:43AM

An addendum:

Don Barone September 12, 2008 08:53AM

Re: An addendum:

RLH September 15, 2008 05:33PM

Re: 7x11 diagonal

RLH September 12, 2008 03:13PM

Re: 7x11 diagonal

Don Barone September 12, 2008 03:34PM

Re: 7x11 diagonal

Rich September 12, 2008 03:44PM

Re: 7x11 diagonal

Don Barone September 12, 2008 03:59PM

Re: 7x11 diagonal

RLH September 13, 2008 01:44AM

Re: 7x11 diagonal

Khazar-khum September 15, 2008 07:50PM

Re: 7x11 diagonal

RLH September 18, 2008 02:09AM

Re: 7x11 diagonal

Khazar-khum September 18, 2008 02:30AM

Re: 7x11 diagonal

MJ Thomas September 18, 2008 07:15AM

Re: 7x11 diagonal

Chris Tedder September 18, 2008 11:25AM

Re: 7x11 diagonal

MJ Thomas September 18, 2008 03:41PM

Re: 7x11 diagonal

RLH September 18, 2008 05:23PM

Re: 7x11 diagonal

RLH September 18, 2008 05:11PM

Re: 7x11 diagonal

Rob Miller September 18, 2008 06:18PM

Re: 7x11 diagonal

Don Barone September 18, 2008 10:40PM

Re: 7x11 diagonal

lobo-hotei September 19, 2008 10:34AM

Re: 7x11 diagonal

Don Barone September 19, 2008 11:27AM

Re: 7x11 diagonal

Don Barone September 19, 2008 06:51PM

Correction

Don Barone September 20, 2008 06:09AM

Re: Correction

Monty J. Bowen September 20, 2008 07:27AM

Re: Correction

RLH September 24, 2008 04:03AM



Sorry, only registered users may post in this forum.

Click here to login